3dprinting:ender3pro

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
3dprinting:ender3pro [2024/12/17 03:41] – [Calibrations] jon3dprinting:ender3pro [2025/04/01 15:14] (current) – jon
Line 60: Line 60:
  
 MRISCOC overview - https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides MRISCOC overview - https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides
 +
 +A nice video overview from someone grabbing their faves from TT and Ellis - https://www.youtube.com/watch?v=rSCwTtJdzo0
 +
 +==== Linear Advance/Pressure Advance ====
 +
 +Perhaps the biggest thing you need to calibrate for is Linear Advance/Pressure Advance. In Marlin, this needs to be enabled. For Enders, this means, a custom compile. If using mriscoc firmware, this also needs a special version that's not on the main release page, but thankfully it is pre-compiled. 
 +
 +MRISCOC docs - https://github.com/mriscoc/Ender3V2S1/wiki/Linear-Advance-(LA)
 +
 +This is covered in the Ellis3dp and Teaching Tech guides, but it will allow you to not have to spend as much time fudging with the other settings to get a print dialed in.
 +
 +Perfect first layer prints - https://www.printables.com/model/213992-perfect-1st-layers-ender-3-v2-ender-3s1-ender-3s1-/comments
 +
  
 ==== Retraction Tests ==== ==== Retraction Tests ====
Line 79: Line 92:
   * https://all3dp.com/2/octoprint-bed-level-visualizer-guide/   * https://all3dp.com/2/octoprint-bed-level-visualizer-guide/
   * https://community.octoprint.org/t/put-tape-on-the-5v-pin-why-and-how/13574   * https://community.octoprint.org/t/put-tape-on-the-5v-pin-why-and-how/13574
 +  * https://print.piffa.net/
  • 3dprinting/ender3pro.1734406894.txt.gz
  • Last modified: 2024/12/17 03:41
  • by jon