Differences

This shows you the differences between two versions of the page.

--- computers:freenas [2021/01/18 19:46] – [Migrating Drive Pool to new Pool] localadmin
+++ computers:freenas [2024/07/09 04:00] (current) – jon
@@ Line 41: / Line 41: @@
 ==== Migrating Drive Pool to new Pool ====
+https://www.youtube.com/watch?v=UflFKgD4RiM
 I've had to do this twice over the years when current hard drive space was getting high.
@@ Line 96: / Line 97: @@
 https://www.ixsystems.com/community/threads/cifs-share-not-allowing-applications-write-permission.18854/
 https://www.freebsd.org/cgi/man.cgi?query=setfacl&sektion=1
+==== Tailscale and using an rsync task ====
+This works with the official community release, or the TrueCharts container. Assuming you're using TrueNAS SCALE.
+Install the Tailscale container inside Apps. For configuration, uncheck userspace (which allows full access to TrueNAS for the container, ie. it runs as root, allowing tasks like rsync to run), check Host Network (allows you to reference the tailscale IPs), and set an advertised route of the IP of the NAS (192.168.0.50/32. for example). You'll also need to set net.ipv4.ip_forward - 1, net.ipv4.conf.all.src_valid_mark - 1 in truenas sysctl under System - Advanced. Of course, provide your auth key from tailscale.
+Sources:
+  * https://web.archive.org/web/20230926115849/https://truecharts.org/charts/stable/tailscale/How-To-Guide/
+  * https://www.truenas.com/community/threads/tailscale-in-truenas-scale-using-truecharts.107185/