Show pageOld revisionsBacklinksExport to PDFBack to top This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. ====== Receiving Images from the ISS via SSTV ====== ===== What's Needed ===== ==== Hardware ==== ==== Software ==== ===== Preferred Workflow ===== * Set up five minutes prior to AOS, set recording to 48khz recording rate, mono. * Turn off squelch * Hit record * Start a two minute timer when I start hearing the transmission, reset when transmission is done and run again so you know when the next transmission will start. I see some people who like to decode the image in realtime with an app or a laptop. If you're at home, sure, knock yourself out. I prefer to record the audio, and then process the audio on an app afterwards. This way, if there are any noises, I can re-run the app with a few changes to try and get the best image possible. ==== Avoiding Crooked or Noisy Images ==== The biggest tip I can provide from my experience is to **not move the antenna** during the transmission. My cleanest images have been from my car antenna, or moving my Arrow Antenna only twice (AOS heading, midway, and LOS heading). sstv.txt Last modified: 2020/10/02 13:27by jon