Bambu Labs P1S

• https://makerworld.com/en/models/383756#profileId-289817
• https://makerworld.com/en/models/385697#profileId-286087
• https://makerworld.com/en/models/119453#profileId-128488
• https://makerworld.com/en/models/238993#profileId-266660
• https://makerworld.com/en/models/236809#profileId-252856
• https://makerworld.com/en/models/183750#profileId-202603
• https://makerworld.com/en/models/142877#profileId-155362
• https://makerworld.com/en/models/57152#profileId-60359
• https://makerworld.com/en/models/40896#profileId-40984
• https://makerworld.com/en/models/53058#profileId-54880

In The BambuStudio app, for PLA at least, the generic profile should be good enough. If you have leftover MicroCenter 'Inland' brand PLA from your Ender, the eSUN profile should suffice.